For simultaneous automatic cutting of two glazing beads at 45°
Highlights
- Automatic cutting of two glazing beads in a 45° angle cut with undercutting of the glazing bead base
- Work sequence without permanent holding of the start button
- Controllable hydro-pneumatic saw blade feed
- Adjustable pneumatic clamping unit with selectable clamping sequence
- No shim change within one profile system required
- Glazing simulation unit for accurate cuts without overlapping of the seals, infinitely variable using hand wheel with counter
- Removal of sawing residues by stripper ring mounted at the guide block
- Easy handling
Options
- Electronic servo length stop with PC control (LAEG 2600)
- Manual measuring system
- Glazing bead simulation automatically adjustable via servo motor (only in conjunction with LAEG 2600)
- Profile-dependent shims
- Profile support in 3 m or 6 m length
- Frequency converter for increasing the cutting speed
- Lateral extraction device
- extraction system
GLS 200/S | Automatic glazing bead saw in full
